Dear Colleagues:I've varian nmr 300, and i've a problem with the spinner that doesn't eject, it stucked like it is frozen,,, the compressor was recently changed and there is a possibility of moisturized eject air , the nmr tube still intact with the spinner and the spinner was clean before inserting the sample
please advice me, and thank you all in advanceEyad Omari
Check if somebody has answered this question on NMRWiki QA forum
Did you find this post helpful? |
Similar Threads
Thread
Thread Starter
Forum
Replies
Last Post
[Question from NMRWiki Q&A forum] spinner problem [Varian]
spinner problem
Dear Colleagues,
my NMR system recently suffers from problems with spinning the sample. Namely, it does not regulate at the set spinning rate at all in any given period of time. The spinning frequency changes continuously and never stabilizes. I wonder what may be the reason for that? Which part of the system should I inspect in the first place looking for the solution? Thank you in advance!
All the best,
D. Kubicki
spinner .... stuck
Linear Mode
